Changing Pattern Speed on Z-Flash OBD for Stellantis

If you have a Z-Flash OBD for Dodge/Jeep/RAM, there is a way to change the pattern speed without needing to use software.

Yes, you can use software to increase the speed, but you can also use your High Beam Stalk.

How To Increase Z-Flash Speed

To change the pattern speed on the Z-Flash OBD for Dodge/Jeep/RAM you will need to have the vehicle and then activate the Z-Flash.

Next, you'll want to push the High Beam Stalk forward and lift it up like you are turning right. If you do this a total of 3 times, you should hit the maximum speed.

Changed The Flash Speed But It's Still Slow?

If you changed the Z-Flash Speed and the overall flashing on your vehicle looks slow, this could mean the majority of your truck, if not all of it is using Halogen bulbs.

If you want the fastest speed possible, you will want to use LEDs.

The Z-Flash only flashes the lights it gets access to on the vehicle. It will not automatically enhance the speed of the lights on your vehicle.

Switching Patterns

If you want to switch patterns with the Z-Flash OBD for Dodge/Jeep/RAM you could use the switch again or do the following:

On the steering wheel, hold the Left Arrow Button and Cancel Button at the same time while the Z-Flash is activated.